Current Sensing Trigger Devices

iSense • Current Sensing Trigger Devices

Item No 6500400 & 6500500

iSense Overview

The iSense series of Trigger Devices are designed to switch an iConnect controlled product, such as projection screens, blinds, AV lifter etc – when a primary AV device has power turned on.

There are two distinct models:

CS1   Item No 6500400   

Features

• Designed to sense 240V (max load 2A)  switch on.
  
• Simply plug the trigger between the power-point and the device it is sensing.
  
• When 240V power is detected a dry contact is closed allowing up / down control of iConnect Devices.
  
• The iConnect motor controller must be reprogrammed with IR transmitter to latched contact mode.
  
• Includes sensitivity threshold adjustment.
  
• Designed when no DC voltage trigger is available in projector / amplifier etc.

CS2  Item No 6500500   

Features

• Designed to sense 5-24 volt DC output from a projector / amplifier etc.
  
• Connects to DC output via 2 core cable (not polarity sensitive).
  
• Connects via RJ12 6 core cable (300mm supplied) to iConnect device.
  
• When DC power is detected a down command is sent / and upon zero detection an up  command is sent.
  
• No need for threshold adjustment.
  
• Powered via the iConnect device.
  
• Must be connected to the Connect Network IN port on the 1st iConnect device.